No, I have not been infected nor am I paranoid to the extent that I’m wearing mask in public.  However it did make me to remember to use my mask when I’m sanding, something I generally forget to do.  I haven’t made a post in awhile, so this will be an update on the two projects I’ve been working on, my dining room table and headboard.

Filling the holes/cracks in my walnut boards of my dining room table is my new skill set.  The first step was taping the underside anywhere epoxy to could seep through. 

20200301_141537I used TotalBoat 5:1 Epoxy Resin, Slow Hardener.  This was a very easy product to use.  I bought the quart size that came with metered pumps.  One pump of resin dispensed the five parts to the one pump of hardener, 1 part.  Mix for at least two minutes and then you have about 20 minutes to work with it.  I was amazed how much epoxy went into small cracks or holes.  I made three trips to the Manufactory before all the holes were filled.  I definitely will have some clean up to do as I applied too much in some areas.  I’ll do better on my next project.  

The only other thing I accomplished on the table was rejoining a set of the boards I split when I first started this project.  The center of the table will be the board I bought from Urban Edge Wood Works, but I wanted a wide board to rest on each side of it.  Only one of my boards was left uncut, so I needed to rejoin at least one. I chose the one on the left.

No pics of the glue up process, but it didn’t come out very well.  The board is barely over an inch thick and I’ll have to plane it more as the seam didn’t line up through the entire length.  I’m hoping I won’t lose the board altogether as my target width of 38″ is dependent upon using it. The joined board has the tape measure next to it in the picture on the left. Shown there is approximately 50″ in width of boards.  I don’t want sap (white of boards) in the center of the table, so once that is cut away I have about 42″ in width.  The picture on the right were the worst of all my boards and still in their original state.  Hopefully they will make the skirt for the table.

The Governor of Ohio has locked down the state, so today was the last day until further notice to work at the Manufactory.  Just as well as it relates to the table as according to Kendall I’ve taken it as far as I can with him and the Manufactory’s equipment.  I’ve brought my boards home where they will stay in my living room until Covid-19 has passed, I find a shop to complete it myself or pay someone to do it.

20200323_132810

Most of the headboard project has been in my basement waiting for me to do the staining, so with the dining room table on hiatus the headboard has my full focus.  My workbench was my first 100% solo build and it will be the perfect surface to assemble the top of the headboard.  The Manufactory let me borrow their biscuit joiner, the only piece of equipment I didn’t have at home, but needed to complete the project.

With my slots made I turned to sanding the inside of all the pieces, so I could finally tackle the stain, hence the mask.  I applied the same custom stain I used on the side shelves.  The color looks perfect against my beadboard section.

I’ve decided to apply polycrylic to the bottom of the top shelf since it will be a surface that items will set on it, three coats.

The rest of the oak pieces will have Danish oil.  I’ll let it rest overnight and the tomorrow I’ll tackle building the box, which brings me closer to the finish line of this project.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s